ABS melding 525TDS
Geplaatst: 03 mei 2016, 20:49
Beste mede bmw liefhebbers ik heb vandaag even mijn 525tds uitgelezen alleen van sommige dingen word ik niet echt duidelijk misschien hier iemand die mij opheldering kan geven. Reden van uitlezen is omdat het ABS lampje soms aanschiet en dan zo een aantal km aanblijft en dan als ik hem uit heb gehad en de volgende ochtend weg ga hij weer uit is en later weer aanschiet
hierbij het rapport
DDE -> 06/B8 - Exhaust-gas recirculation
Shadow-memory:
06/B8 - Exhaust-gas recirculation
Errors after clear:
no errorsShadow-memory:
no errors
A/C -> 15/02 - Auxiliary water pump
Errors after clear:
no errors
SRS -> 01/00 - Internal control-unit fault
03/A0 - Power supply
0E/C0 - Battery disconnection
0E/20 - Battery disconnection
Errors after clear:
01/00 - Internal control-unit fault
03/A0 - Power supply
0E/C0 - Battery disconnection
0E/20 - Battery disconnection
LCM -> 28/01 - Thermal oil-level sensor defect
Errors after clear:
no errors
ZKE -> 94/21 - DWA-LED: open circuit or cable DWAL, KL30
95/21 - Interior security: fuse or cable
Errors after clear:
94/21 - DWA-LED: open circuit or cable DWAL, KL30
LRA -> Shadow-memory:
12/00 - Sensor signal too high
Errors after clear:
02/21 - Error front sensor
Shadow-memory:
12/00 - Sensor signal too high
DIt is dus wat er op moment aan de hand is
Ik hoor graag van jullie
hierbij het rapport
DDE -> 06/B8 - Exhaust-gas recirculation
Shadow-memory:
06/B8 - Exhaust-gas recirculation
Errors after clear:
no errorsShadow-memory:
no errors
A/C -> 15/02 - Auxiliary water pump
Errors after clear:
no errors
SRS -> 01/00 - Internal control-unit fault
03/A0 - Power supply
0E/C0 - Battery disconnection
0E/20 - Battery disconnection
Errors after clear:
01/00 - Internal control-unit fault
03/A0 - Power supply
0E/C0 - Battery disconnection
0E/20 - Battery disconnection
LCM -> 28/01 - Thermal oil-level sensor defect
Errors after clear:
no errors
ZKE -> 94/21 - DWA-LED: open circuit or cable DWAL, KL30
95/21 - Interior security: fuse or cable
Errors after clear:
94/21 - DWA-LED: open circuit or cable DWAL, KL30
LRA -> Shadow-memory:
12/00 - Sensor signal too high
Errors after clear:
02/21 - Error front sensor
Shadow-memory:
12/00 - Sensor signal too high
DIt is dus wat er op moment aan de hand is
Ik hoor graag van jullie